August 15, 20196 yr Hi, fantastic update on my favorite jet! Encountered a little bug on my first flight today: The Nav/Com Frequency knob of the standard GNS changes both frequencies at once: COM and NAV. No matter if you push the knob to switch between both. COM or NAV is highlighted, but if you turn the knob, both frequencies change (the value behind the dot) Can anybody confirm? Edit: Only in the VC. If i open it with Shift-2, it works correct. Regards, Jan Edited August 15, 20196 yr by Paladin2005 added information Regards, Jan Ast Win 11 PC | Ryzen 7800 X3D | RTX 5080 | LG 42 C2 Cockpit 😉 | TrackIR 5 | Octavia IFR-1 | Virpil Alpha on WarBRD, Virpil CM3 Throttle, Virpil Sharka Control Panel | Honeycomb Alpha & Bravo | TM TPM Rudder
August 15, 20196 yr 8 hours ago, Paladin2005 said: Hi, fantastic update on my favorite jet! Encountered a little bug on my first flight today: The Nav/Com Frequency knob of the standard GNS changes both frequencies at once: COM and NAV. No matter if you push the knob to switch between both. COM or NAV is highlighted, but if you turn the knob, both frequencies change (the value behind the dot) Can anybody confirm? Edit: Only in the VC. If i open it with Shift-2, it works correct. Regards, Jan Yes, just tried what you described in P3Dv4.5 and I see the same problem. Will let Mark (FSW) know about this issue. Al
August 16, 20196 yr Commercial Member 9 hours ago, Paladin2005 said: Hi, fantastic update on my favorite jet! Encountered a little bug on my first flight today: The Nav/Com Frequency knob of the standard GNS changes both frequencies at once: COM and NAV. No matter if you push the knob to switch between both. COM or NAV is highlighted, but if you turn the knob, both frequencies change (the value behind the dot) Can anybody confirm? Edit: Only in the VC. If i open it with Shift-2, it works correct. Regards, Jan This bug you found was actually caused from the update back in Feb of this year. I may be wrong. The reason why i think is because when we made the new GPS management tool we added a few other GPS units on the same panel. And i re scaled the GNS530 slightly to fit better. Whenever i scale an animated model i have to unlink all the parts from other parts to xform the new scale size. I forgot to re link the knobs to the visibility condition. So why you were seeing the values change at the same time was because the nav and the com knobs where actually always active/visible. The way this works is when in 1 mode 2 knobs hide and the other 2 show. And vice versa. But we had 4 knobs showing at once. Bug solved. Thanks for reporting. Edited August 16, 20196 yr by Flysimware
August 16, 20196 yr Commercial Member 5 hours ago, QuaxTheSnoopie said: The same issue as before ? Nobody brought this to my attention. I wish i knew as the com knob issue was from the Feb update.
Archived
This topic is now archived and is closed to further replies.