October 3, 20196 yr flew out of KCRW yesterday and the jetways were about 50ft above the terminal. Everything else at the airport was fine. any ideas?
October 3, 20196 yr Go into the GSX settings for the airport and click the small airplane icon. That will align the jetways to the airports elevation. Jon Skiffington
October 3, 20196 yr if you got orbx vectors you need to run the vector tool or exclude it I7-8700k,Corsair h1101 cooler ,Asus Strix Gaming Intel Z370 S11 motherboard, Corsair 32gb ramDD4,, gtx 1080ti Card, RM850 power supply Peter kelberg
October 7, 20196 yr Author On 10/2/2019 at 10:05 PM, Skiff said: Go into the GSX settings for the airport and click the small airplane icon. That will align the jetways to the airports elevation. Where is this located? I cannot find it in the GSX settings.
October 8, 20196 yr Go to the GSX "Customise Airport" page. In the upper right hand corner you'll find a little plane and some elevation values. Mark all the air-bridges on the right of the panel and click on the little plan. That should set it right
Archived
This topic is now archived and is closed to further replies.