May 10, 20206 yr Anyone know if its possible to map the conditioner lever to an axis in P3d ? (as in prop)
May 10, 20206 yr 1 hour ago, julian46 said: Anyone know if its possible to map the conditioner lever to an axis in P3d ? (as in prop) Sure, just treat the condition lever as a Mixture axis since it controls fuel flow to the engines. I use a Saitek TQ and run everything through FSUIPC, but I don't see why you can't directly assign it in P3D. Why is it any different than assigning the throttle axis? Maybe I don't fully understand what you are asking. Al Edited May 10, 20206 yr by ark
May 10, 20206 yr 2 minutes ago, ark said: just treat the condition lever as a Mixture axis "... just treat the condition lever as a Mixture axis..." That's what I do, using Saitek X52. Stew "Different dog, different fleas"
May 10, 20206 yr Author Thanks both - I was trying it as a propeller axis - (I have registered FSUIPC so should be good)
May 10, 20206 yr 1 minute ago, julian46 said: Thanks both - I was trying it as a propeller axis ..... Since you can cut off the fuel to the engines with the condition lever, I think the mixtue axis is the better choice. Al
Archived
This topic is now archived and is closed to further replies.