Hi Folks, I am running P3D v4. 5. No add on airports installed. For some reason The ILS localizers are not aligned with runway centerline at some airports. Few of the examples are

CYYZ ILS RWY 23

CYQX ILS RWY 03

I also updated the magdec.bgl file to see if that fixes the problem but no joy. 

Looking for help to fix this problem. 

Regards 

 

I looked up CYYZ in the Jepp Charts -- the approach is 237 degrees and CYQX is 030 degrees. What is P3D showing? 

15 minutes ago, pgde said:

I looked up CYYZ in the Jepp Charts -- the approach is 237 degrees and CYQX is 030 degrees. What is P3D showing? 

P3D is showing 237 for YYZ RWY 23 and 033 for YQX RWY 03. I am on AIRAC 2005 for addon aircrafts. FYI

 It doesn't matter what airac data you use as the ILS is embedded in the default scenery. Both the ILS 03 at Gander and 23 at CYYZ are off slightly as shown in the pics below. You could edit them with ADE or use a different ADE hopefully with corrected locs.

Edited May 18, 20206 yr by Dave_YVR

1 hour ago, Dave_YVR said:

 It doesn't matter what airac data you use as the ILS is embedded in the default scenery. Both the ILS 03 at Gander and 23 at CYYZ are off slightly as shown in the pics below. You could edit them with ADE or use a different ADE hopefully with corrected locs.

Thank you my friend : ) Is there any good ADE editor you recommend? I used to use AFX but I think it does not work with P3D v4. 

Edited May 18, 20206 yr by waseemsz

Hi,

Dave already suggested above to use ADE. this is the name of the tool.

You can find it here:-

https://www.scruffyducksoftware.com/airport-design-editor

Note You may need to purchase the Pro key to change some of the runway properties but in my opinion is well worth it. And it supports  P3Dv4 and more recently v5.

Regards
Mark

Thanks Mark. 

Regards