I think it's probably something pretty simple that I configured wrong, but I can't figure it out.

System configuration:

• Clean install of P3dV5 - no other sims installed, no legacy P3D, etc
• Latest Aerosoft Airbus Professional (installer 1401)
• FSUIPC 6.0.8 - confirmed working in P3D
• LINDA 3.2.5 - All setup screens show OK
• Airbus Module 1.8
• VRi MCP-PRO on COM3

The MCP will work fine using VRInsight drivers and default FS aircraft.
FSUIPC is registered and working in the sim.
LINDA launches automatically as expected when simulator starts.
LINDA talks to my Saitek hardware just fine (yoke,throttle,panels).
LINDA is able to Sync to Sim and recognizes Airbus A3XX Pro configuration.

The MCP numbers change when dials are rotated etc.
However, nothing changes in the actual Airbus panels in the sim... no dials no buttons nothing.

Edited June 8, 20205 yr by ScotFlieger

Please follow the Fault Diagnosis procedure and email me the logs together with the A3xx config-MCP.lua file.  

2 minutes ago, ScotFlieger said:

Please follow the Fault Diagnosis procedure and email me the logs together with the A3xx config-MCP.lua file.  

Your mail server rejected my email 

Reason: There was an error while attempting to deliver your message with [Subject: "P3Dv5 + Airbus + MCP Not Working"] to [email protected]. MTA p3plsmtpa09-06.prod.phx3.secureserver.net received this response from the destination host IP - 127.0.0.1 -  554 , 554 p3plsmtpa09-06.prod.phx3.secureserver.net :SMTPAUTH: ESMTP No Relay Access Allowed From 173.201.193.235

The email is Linda @ awgiinfosys.NET not .com

Ok problem resolved. In the end, it turned out that I had the wrong version of VRInsight MCP selected, everything else about the configuration was OK. Much thanks to Andrew for identifying the issue.