Hi and thanks for an excellent product.
Unfortunately I have some issues after updating QW to 1.4. I uninstalled fs2crew and downloaded fs2 crew again, but some features do not work. Fs2 crew would not set flaps, V1, V2 and Vr speeds are set two 000 and it is not possible to complete landing checklist etc.
With regards
Thor H

We're pulling and using a lot of data from the FMC.

Ensure the FMC is completed in full and filled out.

 

9 minutes ago, byork said:

We're pulling and using a lot of data from the FMC.

Ensure the FMC is completed in full and filled out.

 

Yes, i`l always do. Have used your fs2. crew programs since fs9  LDS 767, never had similar problems.

Can anyone else reproduce this?

Try re-installing the aircraft pls.

 

Yes Bryan, that's affirm.  Also experiencing the same issue.

24 minutes ago, byork said:

Can anyone else reproduce this?

Try re-installing the aircraft pls.

 

I was wondering if there could be something wrong with the QW installation, but it works perfectly otherwise.
I will still take a full new installation, but it may take a few days before I give feedback due to a lot of work (jobwise) this week.

Unlisted clip of problem

https://www.youtube.com/watch?v=JXm2449OQWs

Edited March 18, 20215 yr by Benzhangar

I can't see the video.

But I just did a very quick test with a clean and fresh install of the latest version of the 787 aircraft.

I ran the Checklist that lists off the V speeds.

The V speeds were read back correctly.  No problems there.

The FO correctly set flaps 5 when commanded to set the takeoff flap.

 

Thank you.  I will reinstall then later and see how it go.

9 hours ago, Benzhangar said:

Thank you.  I will reinstall then later and see how it go.

Also try it in the -8 model series.

QW may have changed some logic in the 9 and 10 models, which are handled a bit differently from the 8 model.

Cheers,

Edited March 19, 20215 yr by byork

Up and working now with the -8, -9 and -10 model series. It seems after I applied the 1.4 update my first flight was in the -9 in which i should have initialized first it in the -8.

Interesting.

I also had my first flight in 787-9 after update, then i tried -8-10  with the same problems. 

I`l try 787-8 first next time i reinstall.

Thor H

I spoke to the QW developers... they said nothing changed in V1.4 that would effect FS2Crew.

So try the the -8 first after doing a totally "clean" re-install, but I really don't see how starting the 8 first should make any difference.

Reinstalled both QW and FS2crew , everything is working now.

First flight in 787-8.

Best

Thor H

Cool 😉