August 5, 20214 yr Hi, can someone explain me how to remove the "0" parameter within the "control send when button pressed".Field If I delete them, and reopen FSUIPC, is back again. The trim via a selected switch at my yoke does not work, maybe because of that "0". But the FSUIPC.ini listed the switch for up/down Tks, Peter
August 6, 20214 yr 10 hours ago, Pitter said: Hi, can someone explain me how to remove the "0" parameter within the "control send when button pressed".Field If I delete them, and reopen FSUIPC, is back again. The trim via a selected switch at my yoke does not work, maybe because of that "0". But the FSUIPC.ini listed the switch for up/down It is not clear to me what control you are trying to use. It would be helpful if you would provide a screen shot of the FSUIPC Buttons and Switches assignment window that shows the control assignment for trim that you are trying to use. Also see this thread in the MSFS Forum -- the info also applies to P3D. https://www.avsim.com/forums/topic/603428-elevator-trim-and-key-input-behavior/?tab=comments#comment-4572627 Al Edited August 6, 20214 yr by ark
August 6, 20214 yr Author Thanks for your quick answer. Here is the link: https://drive.google.com/file/d/12pChuVZLNTP_EptQa7xkhJ3WvT9Pczom/view?usp=sharing In the meantime I tried your above settings, but also with this no joy. Peter
August 6, 20214 yr 17 hours ago, Pitter said: Hi, can someone explain me how to remove the "0" parameter within the "control send when button pressed".Field If I delete them, and reopen FSUIPC, is back again. The trim via a selected switch at my yoke does not work, maybe because of that "0". But the FSUIPC.ini listed the switch for up/down Tks, Peter The zero shouldn't cause a problem, You need to tick the 'Control to repeat when held' box. Hope this helps.
Archived
This topic is now archived and is closed to further replies.