Haven't flow MSFS for few month, when I start it and updated today, I try to switch to VR and get this error, It was working no issue like few month a go, and My Quest 3 is connected via Quest link and I have just flown in VR with XP12. what set up I'll need to look for?

Edited March 9, 20242 yr by C2615

OK, seems my old Oculus app is not up to the task, I can switch to use Steam's openXR interface, or updated to new version.

Not big fan with flat Meta logo at stat... but it get's job done...

On 3/8/2024 at 9:33 PM, C2615 said:

OK, seems my old Oculus app is not up to the task, I can switch to use Steam's openXR interface, or updated to new version.

Not big fan with flat Meta logo at stat... but it get's job done...

I am new to the Meta 3. However, I use the purchased Virtual Desktop app and just load MSFS from there. It works fine.

SOLVED (Please Verify That Your Computer Is Set To Mixed Reality)

If your like me and tried VR with your MSFS2020 and came away with this error

everytime your launched MSFS2020, in effect locking you out of using MSFS2020 because

Clicking on the (OK) Button accomplished nothing, you were now no longer

Able to Click and activate anything within the simulator any longer.

Thank Goodness there were some smart problem solvers in the Flight Sim Community

Because X-Box and Microsoft Support was a Dead End.

Evidently, when I tried VR on my MSFS2020, it installed some mapping to the KEYBOARD and MOUSE

Which when the mouse was touched, it would Activate VR. Below are the steps I followed

With the knowledge gained from prior postings, and this allowed me to have

Control once again of my MSFS2020 program.

 1-Open= (MSFS2020)

2-Don’t Touch (MOUSE) any further

3-Locate on Monitor where the MSFS2020 (OPTIONS) Tab is located. Will need this location in

    Step #7

4-Close= (MSFS2020) with Task Manager

A-       On Keyboard- Keep Tapping CTRL-ALT-DEL until you see Task Manger Pop Up.

B-        With Mouse- Click= (Task Manager)

C-        RIGHT CLICK= (MSFS2020)

D-       Click= (End Task) To Close MSFS2020

 

PROCESS TO DELETE (Mouse & Keyboard) VR INPUTS in Control Mapping

**CLEAR OUT ALL (VR MENU) -Inputs to (MOUSE & KEYBOARD) Control Mappings

5-Open= (MSFS2020)

6-Click= (Continue in Normal Mode)

7-MOVE MOUSE to= (Position On Monitor That OPTIONS TAB was Located)

    NOTE- Don’t Touch Mouse Any Further

8-Click KEYBOARD= (Enter) This will Bring Up The OPTIONS Menu.

9-Use KEYBOARD ARROWS, “Down” & “Right” to Highlight (CONTROL OPTIONS)

10- Click KEYBOARD= (Enter)

11- Use KEYBOARD ARROWS, to Highlight (KEYBOARD) at Top

12- Click KEYBOARD= (Enter)

13- Use KEYBOARD ARROWS, to Highlight (VR) on the Options Menu.

14- Click KEYBOARD= (Enter)

15- Use KEYBOARD ARROWS, to Highlight the (MAPPED) areas in the Menu

16- Click KEYBOARD= (Enter)

17- Use KEYBOARD ARROWS, to Highlight (CLEAR CURRENT INPUT)

18- Click KEYBOARD= (Enter)

19- Use KEYBOARD ARROWS, to Highlight (VALIDATE)

20- Click KEYBOARD= (Enter)

****NOTE; Do the same thing for the MOUSE - (CLEARING OUT VR INPUTS) 

 

This seems like it would be a very good method to remove assignments from the mouse and keyboard without moving the mouse which would prevent completing the task.