Good morning, Dave,

 

I am having troubles using Pilot2ATC in a specific computer. After a quite troublesome installation of English language pack and voices, P2ATC is connected but does not tune any radio frequency and any input does not seem to make any change. Also, when swapping or setting it to COM1 it automatically goes back to COM1.

I have tried the program in a different computer during the free trial period and seemed to work fine. I assume it was because of the language settings. However, now I have the same config in this computer and something is working differently.

I attach a picture of the radio settings. It is not connected in the picture, but when connected it remains the same and no changes can be made.

Thank you in advance

You need to install the update to version 0.0.20, available on the Update tab of the website.  It fixes the COM display and setting issues that were in the older versions.

Dave

It worked, thank you for your help!

Hi Dave

I have the same since update to Early Access 0.1.1 wiith the Inibuilds A350, Version 1.04. Other aircrafts work fine. I also tried with "ignore avionics / battery switch" but no chnages can be made. Until the update to 0.1.0 / 0.1.1 it worked with the same version of Inibuild's A350, eventhough I had to switch the frequencies in the radio panel of the aircraft. Any clue? Thank you in advance.

Regards Roland

 

0.1.2 is out. Try that?

Thank you. At the same time Inibuilds A350 was updated to version 1.05. P2ATC is working again.