flydk

Thanks for your replies, and yes i am useing the "B" button and that does seem to be the problem.

Have flown 2 flights today with 2 different aircraft, however when cleared to a certain altitude eks. FL120 and reaching it the controller keeps telling me i have busted my altitude, when checking my altitude "ctrl Z" the altitude is + - 30 ft of my assigned altitude, is the ATC to sensitive or is it how it should be? allowing for wind and pressure it would be difficult to stay at precisly FL120.FS9.1ASEDA F70Feelthere ERJ 145

I still find it a bit strange in that RC4 sends me to runway 26L (secondry runway) whilst AI traffic is sendt to runway 08L (main runway) for takeoff

Enjoying RC4 very much, what a difference from the fs9 ATC, however i was wondering why RC always uses the secondary runway to takeoff instead of the main runway at EKYT (Aalborg Denmark) my local airport, i do land however on the main runway. Any ideas

I presume you have UAC switched off and installing as Admin and of course not installing in programs(x86) folder ? :( (Install into eksampel C: fligtsim)

Above the middle screen in the cockpit just to the left of the autobrake knob are 2 buttons ENG / SYS pressing one of these should activate the blank screen. However it depends on how your aircraft is setup in the PMDG menu.

Turn the battery on?. On the picture of the overhead panel the batteries are off

Thanks for your answer, that helped.

I had just taken off from AAL for EDI and activatet VNAV and AP but the AP would not engage and GWS R and GWS P showed up in yellow on the PFD. I have no idea what it means and how to get rid of it again, but the AP would not engage.Any ideas anybody??