Abrupto

Hi Bobsk8, I have thrustmaster rudder pedals. Is it possible for you to share your rudder settings? Thank you!

I am not sure if it’s me or the settings of my pedals, but I find it quite difficult to stay centered on the runway during take-off. I have to keep correcting the rudder pedals continuously and sooner or later I overcorrect, and I start some kind of zigzagging along the runway. I have tried to play a bit with the sensibility curve, but I haven’t found yet a good result. I would like to ask to someone that does not have this problem to share the pedals settings. Thank you. HB

Thank you David! I will try that. The vpn server to connect to should be the one from my country or it is not relevant?

I have an overall very good performance, in the departure airport, climbing and cruising but when descending to the destination airport usually between 10.000 and 5.000 feet the sim freezes for a couple of seconds.After that it recovers back. I've tried several tests to track this problem, new drivers, empty community folder, low settings but nothing that I've done has solve it. I'm running an 5800X3D, RTX3080, 64GB RAM PC. Do you have any ideas to share for me to track down what's going on? Thank you!

Hi. Still happening randomly. I have the latest cable as you have. I think it is not related to the G2 but with the sim.We are not alone....https://forums.flightsimulator.com/t/reverb-g2-goes-black/572518/95

Hi, in every flight I do, the Reverb G2 display/lens will suddenly go black and after a couple of seconds, they recover. I’ve searched for a possible solution and found that it could be related to the sound. Lower it as for the suggestions but did not help. Is anyone reading this with that same problem? Any solution? Thank you!

Hello Pete Would you mind to tell me where I can find instructions on how to do the conversation text file using WideClient and a Lua plug-in you mencioned? Thank you!

Hello just installed PMDG 600-700 and trying to do a flight with a 737-700 I've got an SDK error when opening FS2Crew.Is there anything I should do after the PMDG NGX737 600/700 installation and before running FS2Crew? Thank you Best Regards Henrique Barbosa

Hello I just download and installed the PMDG 737NGX 600-700. I already had the 800-900 installed and updated to the latest version SP1c. Do I need to run the latest patch again? Thank you for the help, Best Regards Henrique Barbosa

Hello, yes I am . I found the problem. My speakers were maped to 5.1. Change it to stereo and now the sound is OK. Thank You henrique

Hello, there are three moments that the sound I ear is very bad and I can´t understand it: at T+18, at T+8 and T+1, always ground staff communications. I've searched the manual for troubleshotting this but did not find any guidance. The sound in FSX is maped to the external speakers and voice is maped to my headset. On the Fs2crew CFG audio setup is maped to the headsets. Service interphone is ON. SVC is pressed and volume is up. Can you please help? regards henrique

Hello,thank you all.RegardsHenrique

Thank you Bryant, but how do I set the speed.Say the aircraft is level at 9000 feet 190kts and I want to descend to 3000 feet 135kts. Where do I input the 135kts? As soon as the aircraft descends the speed increases. How to control it?Henrique

HelloI'm a total newbie with this plane so forgive my ignorance. For take-off I select HDG ; ALT SEL; and V/S 1500 fpm. Positive rate gear-up a.s.o. When at crusing altitude if I change to IAS mode the plane starts climbing and speed increases. Can you please tell me which is the right way to go or point me some tutorial to follow?Thank you so muchHenrique

Hello,can you please tell me if I can use Fs2Crew on LVLD Virtual Cockpit with Trackir without issues or CTD? The manual says to load 2D panel by default . After loadind can I move to VC?ThanksRegardaHenrique