Helge Rasmussen

Hi, I have now three times tried to do an high altitude IFR flight using the inbuilt ATC with a flight plan made on the world map. In all three instances MSFS crashed to desktop when I got near the destination airport. Doing the same flights without ATC did not crash. Is this a known issue? Helge

Hi, I have been happily flying the C172 for the last couple of weeks, but starting yesterday, I started having problems with power. I follow normal start procedure and end up with motor running and active G1000. Then, however, sometimes the power suddenly goes away, and the G1000 goes dark. Flaps will no longer move etc. Last time it happened while taxiing, the time before it happened while climbing. This last time I toggled the battery and power returned, then it disappeared again a few minutes later, and this time I could no longer bring it back. As far as I can see I have not enabled any failures- Am I doing anything wrong here?

The problem is gone now. After Googling a bit I saw a suggestion that it was caused by the rudder pedals. Disconnecting them in fact fixed the problem!

I wonder why only I have the problem, as I said I iknow its not the mouse or driver as it works fine outside the cockpit. The best way I can descrive the problem is that if I for instance move the mouse for a with a constant speed,, then sometimes the mouse cursor moves and sometimes it just stops for a while before moving again. Its kinda like in the old days where the mice had balls (Remember them? :), when they got dirty the mouse cursor also sometimes stopped even though you were dragging the mouse.. Nice idea about the track ball, I might try it later.

I took your suggestions (Thanks!) and started to use my mouse, it works fine except that the cursor doesn't always move when I move the mouse. This is extremely irritating. I know the mouse doesn't have any problems, because when I move the camera with the mouse in the outside view its very smooth. Its only a problem in the cockpit. Is there a setting or something that I can tune to make this better?

One reason is that if I open e.g. FSKneeboard, it shows up outside the window, and then I cannot grab and move it with the mouse. Or is there a trick I am missing? Are people in general using the mouse in VR?

Hi, I have mixed luck setting up the quest 3 VR controllers for MSFS. I want to be able to manipulate buttons and switches in the cockpit using the right controller There are some youtube videos that are at least a year old describing this, but non works; I guess the settings in MSFS has changed in the meantime. So, could someone list how they have set up their VR controllers please? Any suggestions for how to set up controllers for VR in general would also be appreciated. Thanks 🙂

Personally I chose Intel for the pc I’m building right now solely because on single core performance. AMD leads in multi-core,and in the end I think both CPUs are fine with a slight advantage for games to Intel. That may easily change with the next generation though. Also, it’s unclear how much pcie4 will be an advantage, especially with the upcomin AMD Big Navi GPUs. Don’t feel bad about your choice:)

I will have to mount the AIO on top of the case as the tubes is too short for correct front mounting. Should I push air out of the case, or into the case here (currently it’s front mounted pulling in and I have fans at the top pushing out). Also, should the fans pull through the cooler or push?

Ok, will do.

Hi, I bought the GTN 750 and 650 from F1 yesterday and installed them using the downloaded setup programs. However, when I try to activate them using the plugin, I get the message: "INVALID LICENSE: CONTACT VENDOR". How do I fix this?

Thanks, I will have a look at it

I know this is an old post, but how does X.-Camera help with this problem? I cannot find a setting in it to disable mouse wheel zoom.

Wow, thanks a lot Manuel, this will help a lot! Helge

Ok, thanks for the replies!