Richard99_Photography

Stunning as always Marcelo, many thanks for your awesome job! Bye.

I am trying right now this setting: - AA Mode: AA_MODE_METHOD_SUPERVCAA_64X_4V12 - Transparency filter: 2x SGSS For now, but let's see what happen at the arrival airport (KLAX by FsDreamteam), it seems to be lighter than 8xS + 2xSGSS. I have not appreciated the image quality (compared than the other setting before) yet. Could anyone explain what kind of filter is exactly the AA_MODE_METHOD_SUPERVCAA_64X_4V12? I tried to get some info but no response on the net.

Hello, am I wrong if I state that this kind of setting is heavier compared than 8xS + 4xSGSS o 8xSQ + 2xSGSS? Anyway, I guess you are flying smoothly because your CPU is pumped up to 4,7Ghz, I don't think this good result can be achieved by other users who run their CPU at lower speeds. But I am interested to give a try. Bye.

@Winky. It is "another world" mainly because you got a super high-end GPU (GTX680) in place of an older one (HD 5870). It is obvious there is no race between those. Anyway, I strongly suggest you (to get a more stunning graphics, as you have a powerful card) to try this setting: 8xSQ + 4x sparse grid supersampling. Bye.

Hi Robert,did you understand why you suggested me to try graphics setting with that link... At all...

Anyone with huge shimmering playing graphics settings posted above in this thread? No matter if I use 8xS + 4xSS or 8xSQ + 2xSS, only way to reduce positively shimmering is setting 2x sparse grid supersampling or 4x SGSS. Unfortunately this has a huge impact on fps, expecially when in VC with PMDG 737NGX.Very very hungry.This problem is greater in some airport addons, less in other... I have just formatted and reinstalled FSX on a separate HDD. It is absolute plain, just two or three airports installed and only the PMDG 737NGX, no other.Cannot continue with this annoying FSX.My specs:I5 2500K @ stock clockGTX560Ti OCP8P67 DeluxeHDD WD Caviar Black

Hello, I have followed this intersting guide. Just two notes about that. I have always choosen both vSync and Triple Buffering ON, while in this guide are set OFF. Does It allow to an acceptable fps increasing (with OFF)? Which are minus points about chossing OFF in terms of:a. graphics quality;b. stuttering problems.Thanks, bye.

I have followed this configuration guide too but unfortunately get lot of shimmers using both 8xS + 4x Supersampling or 8xSQ + 2x supersampling. Then I tried SUPERVCAA 64X 4v12 and must say it reduces about 95% of shimmers or, anyway, most important & annoying ones. Unfortunately (again), it has a huge impact on fps, about 10-15 fps (in VC). I did an approach using VC and until about 100 ft above ground my fps stayed very high (about 22-24, blocked with Antilag at 25), but beyond that point it reduced much until 13-15.Different story about using 2D, where the impact is quite low.@WallysWorld: did you see a so huge impact? I have a GTX560Ti too.@everyone: there is some transparency filter less than SUPERVCAA 64X in terms of fps impact but with a good resolution of shimmers?

Thanks a lot Maarten, really interested to your repaint and hope it will be available soon. Bye.

Hello, I am interested to PDF kneeboard, what about the impact on performance (see FPS) while starting and running as well? Have you seen some frame rate hit? Thanks. Bye.

Hello, very nice repaint. Is it a fictional livery or not?Bye.

Hello, try this: http://www.hdtextures.net/?page_id=332or this: http://simtexture.de/download.php?load=PMDG 737NGX Bye.

There is the link just under the shot!

Very impressing quality Chris, congratulations. But, where can we find that?Bye.

Airbus aircrafts are not permitted here!

Is it not already fixed with Hotfix 3? About the United livery shown above. It is referred to a Boeing 737-500 or smaller, which is no more in the airline's current fleet (see here).Bye.