Katz

Interesting problem I ran into. Not sure if it's because im using this on Prepar3d, but I have a black square in the way. I can't move it and things don't work behind it, also I dont switch changes between myself and the FO. Image Attached!

ive emailed through the contact pagei got it working but i dont know how

Yeh it does look like that,if i say "ground from cockpit" they will respond with "yes" but then i say the pushback commands and get nothing

Yes everything else works.

Yes, the green box comes up with right saying, i just dont get a replyWhile I was going through the flows I clicked the CFG panel and changed the pushback distance and which way the tail went.Would that cause the problem?Do you have to set up all the pushback aspects at the very start?

I have it set up properly, i say "cockpit to ground" they dont reply, if i say "ground from cockpit" i get the reply "go ahead"I then say "we are ready for pushback and engine start" and i dont get a reply

I love the lights on the NGX and want to put them on other aircrafts but when i look in the aircraft.cfg file only the vc lights are there does any one know where to locate all the lights for the ngx?? Thanks, Josh Katz

amazing! look forward to the full document!

Still got one on approach to YMLT, worst timing!

Im having a lot of trouble with joining lines between the fuselage and the tail. Any help is good thanks!

My progress with FlyDubai!

Working on it! http://i52.tinypic.com/w6qlhx.jpg

Ok im really confused. How do i cut it before painting and place it together???

I was going to paint then cut for the 800 but now it makes sense hahaha

Are you sure you're not painting the -800? I don't see appropriate cuts in your master file. Looking at your master shows a continuous curve in that area, I don't see the cut. It's not a -900. Do I need to cut the plane to the -800 prior to painting? I thought the cut points were for after? Thanks a lot for your reply though! Josh