Hi everyone,Well the new year started out good for me, got a new system, nothing major but can run fs9 full tilt while flying level d 767 in vc mode with activesky, ground environment, add-on scenery, etc. etc. @ 30 fps locked.It is a whole new experience compared to say a week ago on my old system where i had to tone evrything down to get 20 frames.now the only problem is while in vc in my old fs9 installed, I had set it up somehow to be able to use my rudder trim button on my ch yoke to zoom in and out to get a better view at certain instruments. Now im trying to get that to work again, I have tried using the "move eyepoint forward and back" under assignments but that wasnt what i had set in my old system. I use to be able to zoom in and out and now cant for the life of me figure out how i did it.Any ideas on how to do that.Thanks and happy new year.

Wasn't that simply '-' and '+' or maybe rather 'shift-' and 'shift+'?

In the [joystick_main] section of your FS9.cfg find the entries for the rudder trim...RUDDER_TRIM_LEFTandRUDDER_TRIM_RIGHTReplace the text with....ZOOM_IN_FINEandZOOM_OUT_FINELeave everything else on those lines the way that it is.Note: if this is too fine, you can delete the _FINE, your choice.regards,Joe

Thank you very much, for those wondering, do as Joe says, that was exactly the way to do it. Thanks again.