Archived

This topic is now archived and is closed to further replies.

kasiday1

ground crew

Recommended Posts

what command switches from ground crew to after engine starteven though ground crew dismissed with thanks for the guidance see ya

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Mode should change from S/CREW ENG START to AFTER ENG START automatically once both engines are started and stabilized.banner_fs2crew_team_kk.png

Share this post


Link to post
Share on other sites
Mode should change from S/CREW ENG START to AFTER ENG START automatically once both engines are started and stabilized.banner_fs2crew_team_kk.png
engines stabilised nothing is happening

Share this post


Link to post
Share on other sites

Confirm again that once you have the engines started and stabilized, the mode in the Main panel stays at S.CRW/ENG START (in yellow) and will not change to AFT ENG START (in white)?If that is not happening and you don't hear the FO flipping switches during is after start flow, we'll need to wait until Bryan chimes in...banner_fs2crew_team_kk.png

Share this post


Link to post
Share on other sites
Confirm again that once you have the engines started and stabilized, the mode in the Main panel stays at S.CRW/ENG START (in yellow) and will not change to AFT ENG START (in white)?If that is not happening and you don't hear the FO flipping switches during is after start flow, we'll need to wait until Bryan chimes in...banner_fs2crew_team_kk.png
confirmedwaiting thx for your concern

Share this post


Link to post
Share on other sites
confirmedwaiting thx for your concern
Are you starting the engines using the FS2Crew voice commands? "Start the left engine"... "Start the right engine"...?Is pushback in the FS2Crew config panel set to required or not required?Pls advise as the mode should automatically change... but you can always do it manually if need be.Best.

Share this post


Link to post
Share on other sites