I have received an update this regarding this last makerwys.exe comment. It will only stop if the missing area number in the sequence occurs after area 999. The capacity of area sections and layers (assuming no area missing after 999) is 9999.

I have just received information that if you have any missing area numbers that makerwys will stop reading and proceed to finalize its data.-----------------------snip----------------------------I don't think the unregistered version will fix anything but it should alert you to possible problems.I did have one missing area but it apparently is not affecting me with makerwys.

I definately think that the problem is occuring when the makerwys stops scanning about 7/8 of the way through the scenery.cfg. Something's kicking it out, even though the FlightSimManager says my scenery.cfg is free of errors. I'm in the process of culling the scenery.cfg list of old sceneries that I don't use anymore to make the list smaller and the process simpler.But I'm still worried by this fact: I know my default addon scenery/scenery folder is getting scanned, because I can see it happening in the makerwys box. But when I put my afcad for RJGG in there and compile, RJGG still won't show up in rc.

I fixed it. I just deleted a big chunk of the scenery I wasn't using, ran the scenery.cfg fault finder, and everything compiled. Makerwys just didn't like one of the sceneries I had installed. Thanks for all the help.

We need to concentrate on runways.txt first. All I can suggest is redownloading RJGG_v2.zip again from flightsim.com, where I just got it, and installing it x:\Common Addon Scenery\ so you have x:\Common AddOn Scenery\RJGG\ with the scenery and texture folders under this, adding and putting RJGG at the top of the scenery list. Your area number max appears to be low enough. The start FS and let it reindex and close it.To insure it can be seen search for but don't save anything with AFCAD221. If there, then run the scenery rebuild from within RC4. Close RC 4 and then search runways.txt to see all sections for RJGG and making sure the last RJGG lists the runways and taxiways. If RJGG is at position 1 on the scenery setup list, then it should be near the last section in runways.txt. Disregard the sections on RJG1 and RJG2. See if RJGG is mentioned in any section and not deleted later.Make sure your last area is under 999 for now and the highest layer is less than 999. That is an FS limitation for FS9. Be sure all other RJGG afcads are not present.

ronzie- you might have posted at the same time as me- read the post above the one you just made.Again, thanks so much for the help.

I fixed it. I just deleted a big chunk of the scenery I wasn't using, ran the scenery.cfg fault finder, and everything compiled. Makerwys just didn't like one of the sceneries I had installed. Thanks for all the help.

it would be nice to know which scenery was the culprit

I don't know- I just went down the list and deleted the ones that I never flew to. Mostly smaller, regional places in the US like Boise and Roanoke, as well as some mexican sceneries. But anyway, it's fixed now.