Hi guys!!i'm looking for an ac adapter that fits in my pro flight yoke system from SAITEK. Even when i know that below the connector is printed 5v 1.5a, i don't know the right pin.Anyone knows the right pin size? I looked everywhere in the manual (?? if i could say manual)and in the box but i couldn't find anything!Pls if anyone has one, or knows the answer i'll appreciate it. Really!!! :( Best regardsIgnacio.

The connector size for the AC Adapter varies depending on what country you purchased the Pro Yoke in. My recommendation would be to go to you local electronics store and by a 5 volt power adapter with a minimum rating of 1.5A.These power adapters will usually come with 7 to 10 different size connectors. You do know the power adapter is only required to use the Yoke as a powered USB hub?Regards,Bob

Thanks for your reply, Bob!Yes i know that's to use the USB hub that comes with. I too have connected the SAITEK rudder pedals and it's better for me to use it in the yoke hub!!I'll do what you recommended.Best regards,Ignacio

Hello I dont think you will need the adaptor with only the rudder pedals and throttle quads connected through the yokeas they are drawing very little, only 100 mA each which is well within the USB spec of 500 mA per bus powered hub.

Hello I dont think you will need the adaptor with only the rudder pedals and throttle quads connected through the yokeas they are drawing very little, only 100 mA each which is well within the USB spec of 500 mA per bus powered hub.

I have to agree especially since I run my Pro Pedals and 2nd Throttle Quad off of the USB ports on the Pro Yoke and I do not use the AC Adapter.

Thanks guys. I thought it wouldn't work correctly. :( I'm gonna try it tonight!Thanks to all!!Ignacio