How do you get the aircraft to hover? Do you need to alter any FS settings or just configure it from the cockpit?

I don't have this particular aircraft, but I guess it's pretty much the same as with the F-35 by Dino Cattaneo or helicopters: It'll take a lot of patience to practice it, but no need of changing any control settings.

I don't have it either but if it uses the same module by Rob make sure your weight isn't too heavy. In the F35 the panel tells you if you're too heavy.

 

Other than that the instructions should be in your manual (Read The Friendly Manual)

It doesn't use Rob;s flap gauge... It's totally new. I would suggest that you contact Razbam's support... (not sure how to do that) perhaps on Facebook?

You check weights by verifying that the STOL capable by hitting Shift-2 to get to the loadout manager. Drop weight and adjust loadout as needed (only able to be done on the ground with p-brake set, aircraft shut down).. When engines are back up, set up STOL or auto on the flaps, 85% nozzle deflection, water on T/O and aircraft facing into the wind. Give it full throttle and slight back pressure on the stick and you should enter into a hover. Practice makes perfect and your hover should improve over time.

 

Razbam forums are linked below.

http://www.razbamsims.com/forums/

 

-Damien