Hello.

 

Based on "FO/Pilot not flying Flow", FO has to turn off fuel pumps off in his Shutdown flow, but he doesn't turn pumps off. I have to do that for him to finish checklist. I follow my flow exactly as it shown in manual. Any ideas?

 

Thank you.

All the pumps or just some of the pumps?

 

Note he leaves the center pumps on if they're not empty... that's deliberate.

 

And 1 forward depends on if the APU is being used or not.

He turns CTR tanks when they become empty but leaves remaining pumps on no matter if APU running or not.

What was your selected power source in the Config Panel?

FS2Crew thinks you're using the APU.

 

Did you manually turn off the APU?

 

The FO will have started the APU after landing, and put the APU on the buses during the pre-shutdown flow.

I do not touch the APU at all. Even though no need to keep all pumps on to keep APU running. To complete checklist fuel pumps need to be in OFF position (except on for APU need if APU is used) and it is FO's responsibility to turn pumps off. So where is the gap? I just don't get it?

Thx again.

Which pumps exactly are not being turned off.

 

Can give me the specific names, ie., left forward, etc.

 

Thanks,

Hi Bryan.

 

AFT/FWD 1 and AFT/FWD 2 are left on all the times. He turns off CTR pumps though when CTR tanks run out of fuel which is good.

I think I pay him too much and he gets lazy. ^_^

OK. I have got that figured out. Sometimes I was calling Shutdown checklist before FO finishes his flow. He turns off fuel pumps off as he is supposed to. My mistake. Sorry. -_-

No worries.