Here's a reference photo to show you what my problem is. That arrow points to an area that should be a large body of water, however, it is displaying as land. I know my scenery order is out of wack. I believe I deleted my scenery.cfg and let it create a new one, so now everything is out of order. I have UTX, GEX, photoreal. In that picture I have MegaSceneryEarth Texas, I tried placing it at the very top and below my UTX entries, but the water still is showing up as land. I tried to go to another photoreal area in St. Maarten where there's a ton of water, and its all land too. Not sure what's wrong. Here's a screenshot of my current scenery library.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

As you run UTX, try running the UTX config tool, and resatrt FSX. Usually this fixes that problem.

Also, all of UTX should be between Propeller Objects and Addon Scenery. You seem to have UTX in different places. try and keep it all together.

Also, AES Basepack should be at #1.

The rule of thumb is

Airports/Afcads >>>>>Top

Ground scenery >>>>>Underneath airports

Mesh /Landclass>>>>>below addon scenery

I had this headache of a problem once before. I recommend reading the UTX manual and also visit the support forums over on flight1 as I found a few posts clarifying which layers need to be placed where.

In general though I would have all my addon airports above the UT layers.

Try downloading the SceneryConfigEditor which allows for quick scenery layer movement outside if FSX http://sourceforge.net/projects/fs-sceditor/files/

Thanks guys for the help. I'll give this a try.