I just purchased the A2A C172 after carefully comparing with other 172s available.  The aircraft is amazing. I am having an issue with my CH Yoke though. It seems fine in flight but whenever I land the plane it veers off the runway to the left regardless of yoke movement, this also happens on takeoff.   I have gone through the calibration at the driver level and even have attempted to set it to default settings but no luck at present.  I have only installed the following

 

P3D v2

A2A 172

Estonia Migration Tool

 

Nothing else.

 

Any ideas would be appreciated.

 

ck all of your controller settings you must have something assigned that you don t know about. The fist thing I did was un assign all controller setting and then re assigned them as P3D when fist installed assigns all sorts of stuff to different controller buttons.

I have done what you suggested with no help. Interestingly enough, the plane steers perfectly using p3d v1.4. I did an uninstall and reinstall of p3d v2 and a2a and it still veers left.  Mouse yoke even appears to veer left.  Anyone running p3d v2 with the CH Yoke and steering ok?

Do you have any other controllers plugged in?

Could it be the Realism settings in P3D are having this effect? The action you describe is what happens in a real aircraft due to prop rotation. Realism settings in the sim control how "real" the model performs. The Easy setting removes all these effects.

When i plugged in a simple Logitech Joystick i also noticed the veering to one side. Go outside to look at the rudder. In my case i could move the rudder from center to left, but not to the right at all. Not even with the standard key (Num Enter).

I did not try to reset the controls. Will try the full Yoke setup today.