Hi guys,

 

Sorry if this has been asked before.
I've recently ripped apart a xbox360 wired controller and decide to make a switch panel using all the circuitry involved in the controller, all is looking good. My plan is to start with Cessna 172 but how do can i program the switches. I havent got all my resistors yet, so i haven't started trying. I was thinking of FSUIPC but it appears not all of the switches ie (Beacon Land Taxi Nav Strobe Pitot & Fuel Pump) are listed. Is there any way i can do this (maybe LINDA)?

 

Thanks

You might want to check out our Hardware Forum and look for the Controllers Forum while waiting for an answer here.

 

Best regards,

You might want to check out our Hardware Forum and look for the Controllers Forum while waiting for an answer here.

 

Best regards,

Hi,

Being new here I struggled to find my way the forum mentioned above, but I'm learning all the time, I think I found my answer FSUIPC and LINDA is required.

 

Thanks Phil

I did find that FSUIPC was ideal. I also added a second usb keyboard& remapped the keys using FSUIPC as well as the sim's deafault assignments. I grouped the keys & colour labeled them. Do not forget that this will duplicate the main keyboard, so a bit of thought is needed. In actual fact, you only need a few actual sim key assignments on the main keyboard. The majority goes onto the 2nd keyboard.

Great fun, we found, & it adds to the immersion factor.