Hello, i've a problem with landing on EHAM 18C ILS 109.50/183, B736 not on centerline

My NAVIGRAPH AIRAC cycle is 1508

FSX/P3D Navaids 1508 update Herve Sors is done

There is a solution please?

 

Hi Herve,

I'm not sure if this applies to you, but I suggest you check out page 88, third paragraph, of the PMDG 737NGX Introduction document (it's about the option SET FSX LOC CRS).  If you do not have that particular simulator configuration option set to ON, this is what could happen even though you have set the correct localiser course.  The explanation is in the document.  Hope this helps.

Holy cow,my grass :smile:

 

Peter

PMDG 737NGX Introduction document (it's about the option SET FSX LOC CRS)

 

Hello EmileB, thank you, i've found it in the manual, but sorry, i realy dond't no how to fix this, it is possible to install by what data indicate please?

 

Regards Jaap Mooijer

Hello EmileB, thank you, i've found it in the manual, but sorry, i realy dond't no how to fix this, it is possible to install by what data indicate please?

 

What can't you fix? If you are looking for the option Set FSX LOC CRS, it is in the FMC in the PMDG settings, Simulation page 2/3

Thank you, as is the situation now, with no ghanges yet

 

 

Regards, Jaap

 

You can try also the registry fix tool as mentioned on that thread on the post #7:

 

http://www.avsim.com/topic/473307-my-777-lands-near-runway/

Thank you, I have performed the procedure, now i've to try 18C again..

Unfortunate, but it has not helped

I see something strange now in the second screen, left is 183 and right is 186 degree, in MCP screen Nr 1 is also a differend between left and right, so far i can see?

 

Regards, Jaap Mooijer

 

 

I see something strange now in the second screen, left is 183 and right is 186 degree, in MCP screen Nr 1 is also a differend between left and right, so far i can see?

 

WOW! How did you get TRK UP on the left ND and HDG UP on the right ND? You can choose between these two settings but for both NDs at the same time.

Also, if you have selected a valid ILS frequency on the right radio control panel you shouldn't have this warning on the right ND.

Something went definitely wrong.

The ils data comes from the afcad file. Are you using default scenery? There are updated afcad files in the avsim library or pay airports like from Aerosoft. - David Lee

 

WOW! How did you get TRK UP on the left ND and HDG UP on the right ND? You can choose between these two settings but for both NDs at the same time.

Hello, i will thank you all for helping me. (last night Internet outage)

In my next flight i have turned and pushed on left and right nd buttons   until the directions in both displays were the same again (not first) now my landing was quite right. :rolleyes:

 

 

 

Regards, Jaap Mooijer