December 13, 20169 yr Hello everyone, I am currently in the process of evaluating options to expand my flight sim hardware! I had the Saitek Pro Flight System (Yoke and Throttle) but i had a minor accident with the throttle and I need a new one. Seeing all the problems with the availability of it, I began to think about the CH throttle quadrant. My question is, will I be able to use Saitek's Yoke with it (or my Logitech attack 3 joystick) or will i have compatibility issues? I am currently using FSX:SE. Thanks a lot in advance, any advice on how to actually operate both at the same time is much appreciated!
December 13, 20169 yr Hello everyone, I am currently in the process of evaluating options to expand my flight sim hardware! I had the Saitek Pro Flight System (Yoke and Throttle) but i had a minor accident with the throttle and I need a new one. Seeing all the problems with the availability of it, I began to think about the CH throttle quadrant. My question is, will I be able to use Saitek's Yoke with it (or my Logitech attack 3 joystick) or will i have compatibility issues? I am currently using FSX:SE. Thanks a lot in advance, any advice on how to actually operate both at the same time is much appreciated! I don't have your setup but I do use a ch products yoke and Rudder pedals along with a Saitek x52 for the throttle. use quite few buttons on the x52 for EZdoc . (This for P3D .) never had any issues. bob
December 13, 20169 yr I have them both attached, use the Saitek throttle when flying a single seater, and the CH for 2 engines. No conflicts at all, only thing is I haven't been able to do is set up the CH to do reverse. So I use the Saitek throttle to put it into reverse. I know you can but I struggled to on windows 7. Updated to 10 and haven't retried since as it is not a big issue for me. I find it a good product (although I did get it cheap 2nd hand on ebay) 3080rtx on a i7 12700k with 32 Gig ddr5. 2gig Ssd Quest 2 Windows 11
December 13, 20169 yr Hi, I use the Saitek Pro Flight Yoke and two Saitek throttles (to control all my two engine planes). I also use the CH throttle quadrant for landing gear, parking brake, and my one 4 engine plane. I use the toggle switches to control my EZDOK views. Never had any problems. Works fine. I'm using Win 10 and P3d. Jim
December 18, 20169 yr Author Thanks for your help! Do you configure them through fsuipc or the standard fsx config?
Archived
This topic is now archived and is closed to further replies.