Repeated right engine failure on Realair TD V2 in P3DV4

[Dean33]

Repeated right engine failure on Realair TDV2 in P3DV4

No matter how careful I am I can't stop losing my right engine with no warning at about 1500ft. 

It happened with my original P3DV4. Even if I set it to forgiving and no random engine failures. 

I uninstalled and the installed Sean's new installer. Excited! But it still happened!  

Following proper start procedure. Warmed up. Set revs at 100% (and later less than 100%) so when I set throttle halfway it settles (after a few minutes) at 2200 (or 2150). 

Then I increase throttle to only  1000 well below limits. 

Monitoring all settings and no warnings. Takes off nicely and climbs - then BANG the right engine fails. 

I tried altering configuration (as Admin) and disabled both engine failures. Same results!

Help please!

[jabloomf1230]

Try starting with the default P3d4 scenario, then change the aircraft to the TD Duke. Next, load a flight plan and answer "Yes" to moving the aircraft to the departure airport. Fly and see if the problem continues or not.

[MartinRex007]

Make sure you have the "Oil doors" open on take off so the engine won't overheat?

Martin

[GCRR]

Hi Gents,

stupid question : where can i get the native P3D4 installer for the Turbine Duke ? I haven´t seen any announcements here !

Regards, Lars

[Dean33]

7 minutes ago, GCRR said:

Hi Gents,

stupid question : where can i get the native P3D4 installer for the Turbine Duke ? I haven´t seen any announcements here !

Regards, Lars

http://realairsimulations.net/

 

enjoy!

[GCRR]

Of course !

i must have been blind, thought their website was dead .

 

Thank you so much :)

Regards, Lars