I bought the software yesterday 2018-04-22.

Installed it, Run Configurator as Admin and P3D v3 also.

Today I followed the instructions and  selected the N key as the Button Control for Propeller Sync (on/Off). As indicated in the Manual 

And it does not work anymore. I remembered that yesterday I assigned it to AUTOFEATHER (Arm/Off) event. So I changed it back to that.

And it works. So what is wrong here?

Bat

 

 

Please assign the "N" key to "Autofeather Arm / Off".

That's used to open the FS2Crew Main Panel.

For the other assignments, use different keys, like C or V.

If the main panel doesn't open, look at the panel.cfg file for the Dash 8 (with Notepad) and check if there are any FS2Crew entries on it.

You can also open the Main Panel (in P3D v3+) via the Vehicle -> Instrument Panel menu.

 

Bryan,

I just installed this in P3d 4.3 The entries are showing up in the panel config, and 

Vehicle>Instrument Panel but it's not working. 

Did you install the P3D V4 (64 bit version)?

Sometimes users try to install the old 32 bit version, and that won't work in a 64 bit environment.

 

Is that a separate purchase?

For P3D 64 bit, yes it is:

https://www.fs2crew.com/cart/categories/Special-Majestic-Dash-8-Q400-Area/