July 20, 20196 yr Hello together I'm working my way into the procedures as a PF. Almost everything works fine. After landing the PM sets the flaps to CONFIG 1+F. What do I have to do, to make him set the flaps to CONFIG 0? Thanks Stefan Edited July 20, 20196 yr by Stefan01 regards Stefan Liebe
July 20, 20196 yr Which OAT did you have when this happened? The PM will leave the Flaps at 1 when OAT is above 30° which is SOP on most Airlines to avoid Bleed Duct overheating. Greetings Michael
July 21, 20196 yr Commercial Member 3 hours ago, Binford said: Which OAT did you have when this happened? The PM will leave the Flaps at 1 when OAT is above 30° which is SOP on most Airlines to avoid Bleed Duct overheating. Greetings Michael Very good 🙂 I'm impressed 🙂 B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
July 21, 20196 yr Author That's it .OAT was 35C But it seems that in this case the after landing checklist does not accept the answer CONFIG 1+F. Only RETRACTED is accepted. Is this ok? Thanks a lot Stefan Edited July 21, 20196 yr by Stefan01 regards Stefan Liebe
July 21, 20196 yr Commercial Member Hi Stefan, The After Landing checklist should still accept "config 1". Do you not see that in the green bar? I'm adding "config 1 plus f" as a possible response for for V1.1 B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
Archived
This topic is now archived and is closed to further replies.