7 hours ago, byork said:

The above comment was related to taxi-in, not taxi out 🙂

The PM will set the Takeoff Flaps during this After Start flow.

Are you triggering the After Start flow?  I suspect you're not.

During After Start flow, PM will also:

Arm Ground Spoilers and attempt to set the Pitch trim.

You'll also see the After Start text flashing in the FS2Crew main panel.

If the flow is in fact being triggered and the flaps aren't moving, it's probably because you have external hardware over-riding the flaps.

 

Ok Bryan I’ll keep trying I mean it’s not a big deal whatsoever I can set the flaps myself it’s only one button on my keyboard lol. Thanks for replying and keep up the great work I’ll keep playing around with it till it works I’ll try a complete reinstall of the software 😃

Edited September 3, 20196 yr by Navigator43

A re-install won't make a difference.

You ensure you hit the trigger for the After Flow flow.

Cheers,

 

Just now, byork said:

A re-install won't make a difference.

You ensure you hit the trigger for the After Flow flow.

Cheers,

 

After flow ok thanks that’s probably where I’m going wrong 

Pardon... After Start flow.

This is for voice... but the same applies to button:

 

Question:  The After Start flow doesn't trigger in Voice Control:

Answer:

Required Triggers:

"Starting Engine 1" spoken and detected <--- That's what you're probably missing.  Ensure it's showing up in the Green Bar.

Mode: After Start Checklist

Engine Mode Selector back to NORM.

On 9/3/2019 at 10:21 AM, byork said:

Pardon... After Start flow.

This is for voice... but the same applies to button:

 

Question:  The After Start flow doesn't trigger in Voice Control:

Answer:

Required Triggers:

"Starting Engine 1" spoken and detected <--- That's what you're probably missing.  Ensure it's showing up in the Green Bar.

Mode: After Start Checklist

Engine Mode Selector back to NORM.

Figured it all out Bryan of course it’s my fault again. Apparently I was trying to get the PM to set the flaps in a loaded panel state, well that don’t work. When I put the aircraft in the panel state of just APU running and ran through everything it worked with no issues. Thanks for your replies 

Glad you got it sorted 🙂

The problem was you already had the engines running, and would therefore not need to set the Engine Master back to Norm (and therefore miss the trigger).

 

11 hours ago, byork said:

Glad you got it sorted 🙂

The problem was you already had the engines running, and would therefore not need to set the Engine Master back to Norm (and therefore miss the trigger).

 

Exactly