Hello, finally getting the chance for my first flight after buying this in the Black Friday sale.  
 

A few issues I’m hoping someone here can help with:

- GTN750: I ran the executable to enable this and it’s in the virtual cockpit but I can’t click on any part of the screen, there is no response.  It’s frozen at it’s start up page.

- Since I couldn’t use the GTN750, i proceeded to try and program my route into the FMC.  I was able to input my start and end airports, but was unable to input my sole intermediate point, YCO.  When I tried to do so and pressed enter it simply would blank out the line i was trying to enter it on.

- When trying to fly my route using LNAV, the plane would just keep turning to heading 360 and would maintain that heading.  My desired route was ~335 degrees.  I was a valid intercept heading, I had pressed the FMS button below the FMC and FMS was displayed in the upper right corner of the EHSI.  I used the NAV button on the autopilot, but it just kept turning to heading 360.

Thanks for any help.

I have had no issues with the GTN750 in the ATR. I believe you have to use a key shortcut (shift + 9 in my cast) to expand it. 

Are you able to use the touch screen in the virtual cockpit?

Do you own the payware GTN750 and does it work in other aircraft?

Hi Bert, I do own the Flight1 version.  I tried it in another aircraft and it worked.  I then loaded the ATR and it now seems to work in that aircraft now too.  Not sure what happened but the problem seems to have sorted itself out.

Thanks