Qualitywings 787 glitch

[mikail1304 0]

I recently purchased the qualitywings 787 for p3d V4.5 but if i enable the autopilot the aircraft starts pitching up and down aggressively.

[AnkH 2,233]

Ehm, you are aware that you miss like 99% of the relevant information here? Lets start:

- which one of the 787?

- did you fly with an active flightplan in your FMC?

- did you activate any other mode for the autopilot or you simply press the autopilot engage button?

- if you had an active flightplan, from where to where were you flying?

- did you read the manual? Did you set up your flight according to the manual?

- do you use any other addons that potentially interfere with this plane (e.g. AccuFeel)?

Plenty of questions to answer before we can even think about solving your issue...

[mikail1304 0]

6 hours ago, AnkH said:

Ehm, you are aware that you miss like 99% of the relevant information here? Lets start:

- which one of the 787?

- did you fly with an active flightplan in your FMC?

- did you activate any other mode for the autopilot or you simply press the autopilot engage button?

- if you had an active flightplan, from where to where were you flying?

- did you read the manual? Did you set up your flight according to the manual?

- do you use any other addons that potentially interfere with this plane (e.g. AccuFeel)?

Plenty of questions to answer before we can even think about solving your issue...

i fly version 1.2.1

it happens with and without a flight plan

yes i tried level change , vnav and vertical speed mode and it stil happens

 it happens on all airports

yes

the only addons i have are gsx , tomato shade and ultimate traffic live (i tried disabling them but it still happens) 

Edited April 3, 2020 by mikail1304

[CaptKornDog 281]

Have a video or screenshots?

[TurboKen 221]

I have never had this issue with the 787. However, I have with the Phenom 300. What I noticed with the phenom is I must be fairly level in flight before engaging the AP or it will pitch up and down to compensate for the needle chasing the altitude setting if you will. IF not in level flight with the 787 maybe this is causing an issue with your setup. Just something to try.

[mikail1304 0]

On 4/3/2020 at 7:00 PM, TurboKen said:

I have never had this issue with the 787. However, I have with the Phenom 300. What I noticed with the phenom is I must be fairly level in flight before engaging the AP or it will pitch up and down to compensate for the needle chasing the altitude setting if you will. IF not in level flight with the 787 maybe this is causing an issue with your setup. Just something to try.

i tried that but it still happens. But i noticed i does not happen at high altitudes