Hi,

so, I have this issue when rotating autopilot knobs using the mouse wheel. This started happening in the middle of a flight and doesn't go away even with restarting the entire PC. This only applies to certain knobs, but usually at least heading selection in most planes, sometimes altitude too. The rate of change is now 10x of what it used to be, ie. heading changes 10 degrees with each step of the mouse wheel, altitude changes 1000ft. By clicking the knobs I can increment it at smaller steps, but that's a little inconvenient sometimes.

If anyone is able to give any suggestions as to why this is happening, I'll be forever grateful.

Aleksi

What flight controls are you using?  I use the Honeycomb Yoke and had to remove all the assignments (other that primary flight surfaces) and set them up in FSUIPC to get rid of that specific issue.

2 minutes ago, sgreen91 said:

What flight controls are you using?  I use the Honeycomb Yoke and had to remove all the assignments (other that primary flight surfaces) and set them up in FSUIPC to get rid of that specific issue.

You don’t happen to have an I d iot proof guide  to setting it up like that do you? I can’t get the extra buttons 33+ to work with that lua script for the life of me, nor find out what command to use for the bus 1 and 2 avionics! 

Edited September 9, 20205 yr by Ianrivaldosmith

Search this forum for my post linking to instruction on the FSUIPC forum. 

This should do the trick!
 

https://www.avsim.com/forums/topic/583444-17140-fsuipc-fix-for-honeycomb-10-deg-hdg-trim/

11 hours ago, sgreen91 said:

What flight controls are you using?  I use the Honeycomb Yoke and had to remove all the assignments (other that primary flight surfaces) and set them up in FSUIPC to get rid of that specific issue.

I don't have AP stuff assigned anywhere, I use mouse wheel on cockpit knobs. Issue only happens with mouse wheel, not when clicking the knobs. Guess I have to look into FSUIPC too, been out of the loop for a few years now. I used to have FSUIPC for FSX.