Hi Folks

I have the Logitech G ProFlight Yoke System, Logitech G Rudders and Logitech G Throttle Quadrant. The Yoke and the Rudder Pedals are depicted in the MS2020 Controls, and they work perfectly well. However the Throttle Quadrant, which is connected to the Yoke by a 6 pin plug, is not depicted. The throttle lever, left hand on the quadrant, controls the engine speed no problem, but I'm unable to map the central lever to "Increase/Decrease Flaps. It defaults to "Feather". I'm also unable to set the right hand lever to "Spoilers". There are also 6 switches on the Quadrant which I can't map. Anyone with this setup had success?

Andy

Don't know if I'm helping but all of my flight yoke stuff works. Logitech yoke, throttle quadrant, extra throttle quadrant, switch panel and rudders work fine. Did you install the plug-in? https://support.logi.com/hc/en-gb/articles/360024692354--Downloads-Flight-Multi-Panel. Not sure if this plug-in is the one you need though.

4 hours ago, andy a said:

Hi Folks

I have the Logitech G ProFlight Yoke System, Logitech G Rudders and Logitech G Throttle Quadrant. The Yoke and the Rudder Pedals are depicted in the MS2020 Controls, and they work perfectly well. However the Throttle Quadrant, which is connected to the Yoke by a 6 pin plug, is not depicted. The throttle lever, left hand on the quadrant, controls the engine speed no problem, but I'm unable to map the central lever to "Increase/Decrease Flaps. It defaults to "Feather". I'm also unable to set the right hand lever to "Spoilers". There are also 6 switches on the Quadrant which I can't map. Anyone with this setup had success?

Andy

I have two saitek throttles also 6 pin is not being seen by sim - usb is - thought it was just me guess not 

I have driver software installed as stated above - that software sees it but not flightsim 

Edited October 16, 20205 yr by Richard Sennett

2 hours ago, Daytona125 said:

Don't know if I'm helping but all of my flight yoke stuff works. Logitech yoke, throttle quadrant, extra throttle quadrant, switch panel and rudders work fine. Did you install the plug-in? https://support.logi.com/hc/en-gb/articles/360024692354--Downloads-Flight-Multi-Panel. Not sure if this plug-in is the one you need though.

Many thanks for your reply. I had been checking for Logitech updates, but the last time was probably a day or so prior to release.I have now updated with some success. The Throttle Quadrant is still not depicted, but I have now mapped the flaps to extend and retract, albeit not incrementally..but hopefully that will be resolved at some stage.

Again, my thanks for your kind assistance.

Kind regards

Andy

49 minutes ago, Richard Sennett said:

I have two saitek throttles also 6 pin is not being seen by sim - usb is - thought it was just me guess not 

I have driver software installed as stated above - that software sees it but not flightsim 

Yes, I was beginning to think "it was just me" also. I have updated as per the Daytona125 post. (see my reply above).

I saw a post a few days ago on this forum where a screenprint of  Honeycomb Alpha yoke was used, together with a Logitech Throttle Quadrant, and the Quadrant was depicted in the MS2020 Control section.

Thank you for replying.

Kind regards

Andy