For many years i enjoyed my FS9 iFly 737 with home-made Arduino-based panels: overhead, MCP, EFIS, Nav/Com.  This was pretty easy thanks to the great iFly2FSUIPC interface.

All that went to waste when I switched to MSFS... until???  unless???

So, my question:  can somebody let me know if that brand new PMDG737 comes with a full complement of Lvars/Hvars which might allow me to put my hardware to good use again?

That would be great news!
Thanks,

Philippe

The new PMDG 737 for MSFS uses the same code base as the PMDG B737NGXu in P3D +a brand new exterior. So your old interface should work. You will need to enable datatransmission in the PMDG option file in the package's work folder. 

Thanks for the good news. I had better learn a bit about LINDA, then.

What about Mobiflight?

 

Hello,

i have also a Homecockpit, but never with PMDG. But since Prosim is really worse in MSFS i want to change to PMDG.
I have SIOC, Pokeys and a Sismo Aft Overhead.

But i could not find a solution to bring the PFD/ND/EICAS and CDU Screens to my network PC's??

Is there a Solution available ?

Thanks
Matthias