July 3, 20241 yr When starting MSFS, an update occurred which also caused all my settings to be reset. I have managed to restore all previous settings except alerions and elevator. I have a Saitek yoke. When I go to the Control settings, everything seems to be set correctly. When I turn the yoke left and right the white line under alerions moves back and forth. Same is true of the elevator. When I push/pull the yoke, the white line under Elevator moves back and forth. My problem is that none of this works in the actual aircraft. I've tried both the DA62 and TBM930. Neither aircraft responds to my turning the yoke. The animations work but the aircraft does not move. Will someone please point me to what I'm missing? Tom
July 4, 20241 yr Commercial Member Probably of little use, but you don't have the AP on by mistake do you? Cheers Paul Golding
July 4, 20241 yr Check your assistance settings? People have reported before after an update their assistance settings have been turned ON which messes with manual control. Good luck! Russell Gough SE London
July 4, 20241 yr Author 8 hours ago, sloppysmusic said: Check your assistance settings? People have reported before after an update their assistance settings have been turned ON which messes with manual control. Good luck! Thank you. Auto rudder was turned off, Tom
July 4, 20241 yr If you happen to be in active pause, then that will produce this problem. Or the if the cursor is on another screen. 5800X3D, RTX4070, 600 Watt, one or two 1440p 32" screens, 64 GB RAM, 4 TB PCle 3 NVMe, Warthog throttle, VKB NXT EVO stick, Honeycomb Alpha yoke, CH quad, 3 Logitech panels, 2 StreamDecks, Desktop Aviator Trim Panel. Crystal Light VR.
Create an account or sign in to comment