I try the XP 12 demo with Cessna 172 G100 in VR with a HP Reverb G2 headset. The view through the propeller is flickering with a distorted view as a result. What could that be and what setting could fix it

I'd like to know this too.
(It's less noticeable in XP11 than in XP12).
 

It’s because you have Motion Reprojection enabled. Disable it and the swimming distorted stuff goes away. 

Alternatively simply turn off the engine.

1 hour ago, Litjan said:

Alternatively simply turn off the engine.

🤣

4 hours ago, Litjan said:

Alternatively simply turn off the engine.

Jokes aside, I use a replacement texture that makes the prop transparent.

4 hours ago, Sims Smith said:

Jokes aside, I use a replacement texture that makes the prop transparent.

I'm using this solution for C172 in XP11, but I haven't found any similar textures for C172 in XP12. Where can I download/obtain them ???

2 hours ago, Bulva said:

I'm using this solution for C172 in XP11, but I haven't found any similar textures for C172 in XP12. Where can I download/obtain them ???

Same one from XP11, I am also using.  

I think I tried using this with XP11, but something went wrong. Probably because I'm not using fully transparent textures, but 80% transparent ones (I think). I'll check it again.

21 hours ago, flch777 said:

It’s because you have Motion Reprojection enabled. Disable it and the swimming distorted stuff goes away. 

It is true that the distorted view through the propeller disappear. But instead I got other problems. Part of the terrain flickering. Worse performance (also a google search warned about this)

Then at start my view is close to the floor and I have problem using the menus. Are there no center view command in XP12

Reset VR View