SKYWARRIOR

Hi, I would like to do this as well but am unable to find the folder or indeed where VOX is on my computer. Can you help please Regards David

Hi I experienced something similar when I started as I was using the center button on a CH yoke. I still use this button BUT press it again when I have finished the message, as if to send it. It works for me as they say. I used to sit and wait for a response for ages and it was very frustating. Regards David

"I also have the setting Type=SPECIAL to keep the windows from disappearing when toggling full screen. " I would like I would like to have this as well, is it just a matter of adding this whole string as above please? regards David Regards David 0 Hi,

Hi, I had an instance of mismatch taxiways to the wrong runway this eevening at Sonomish airport. I talked of taxiway H which is not shown on the airport plan at all. Funnily enough I had just updated the database before flying as I had downloaded mega scenery for the Washington area and wanted to be corrct jsu in case. I have new Level -D 767 data just downloade at the last cycle so I am not sure where this is going wrong. so Updated FSC9 without problem and updated VOXATC no problem but this was the outcome. Any ideas welcome Regards David

Hi, I had a similar situation when I started usin g VOXATC recently. I use the same C&H yoke and the central red button for PTT. However I was pushing then talking then relaesing the button and nothing happened from the ATC side. Then by accident I pressed again just after my message had finished and low and behold the letters wen a different colour and I had a response. So evry tim I just releae the button when finished and then press once again. Hope it works for you as they say regards David

Hi I will check both of the above but I know the screen image is absolutley beautiful and I seems to remeber it was 5030 x 1080 0r 1200 but i am sure its tops. I use a Nvidia 680GTX with 4mg ram. s you can see I normally prefer a Mac Regards David

Hi, I have recently bought three Dell 27" IPS screens which I am very pleased with EXCEPT I have one which exhibits fine horizontal lines over 2/3 of the screen after startup. I am using a digital triple HTGO unit which I prefer to the Three output Nvidia 680 GTX 4 g ram which I could use. The screens boot to the password and when going to desktop, but sometimes the original 2/3 screen on one has fine horizontal lines over the desktop. Mostly a restart does the trick but occassionaly its two that ist required. Any help welcome Regards David

Hi I have FSC( .2 and whilst it seems to create a FX flight plan which appears in my doc file whenI go to load it it does not register at all. Any ideas why ? Thank you any help welcome Regards David