gokbuy

https://www.openpr.com/news/1131816/Flight-Simulator-Market-Key-Players-Forecast-by-2025-Fidelity-Technologies-Corporation-CAE-Cassidian-Boeing-HAVELSAN-Alenia-Aeronautica.html

already done, same problem

Hi, Altough i have many addons like FTX Global, LC, Vector, payware airports etc when i click Scenery Library menu nothing comes, only an empty page As far as i know, i have to see all the scenery files here to allow me to enable and disable them. Also Flytampa Athens airport is installed into a FLY TAMPA named folder under the main P3D folder , by the setup file automatically , but not under Addons/Scenery folder. And i can not see this airport, although installed successfully Any ideas about the reasons ?

Hi, Altough i have many addons like FTX Global, LC, Vector, payware airports etc when i click Scenery Library menu nothing comes, only an empty page As far as i know, i have to see all the scenery files here to allow me to enable and disable them. Also Flytampa Athens airport is installed into a FLY TAMPA named folder under the main P3D folder , by the setup file automatically , but not under Addons/Scenery folder. And i can not see this airport, although installed successfully Any ideas about the reasons ?

i installed the sceneries outside main P3D folder, named "flytampa installation" folder run P3D Menu - World - Scenery Lib. Add Scenery - It doesn't add here..this is the problem

i tried to add them manually but its not working. no problem with the installation tough

I can not have these airports working under V 3.1 I followed all the instructions like installing to a separate folder and adding the scenery afterwards but nothing is working This is what recommended at flytampa site I can not see the airports after installation , only standard scenery comes. any recommendations ?

and what did you do ? use p3d without mesh or go to another siumaltor

all in the same folder. i have installed it successfully many times before. problem starts with V3.1

running as administrator. I am not using C drive

I can not install FS GLOBAL 2010 MESH after i changed my Prepar 3D from V3 to V3.1 V 3.1 is a fresh install. I also dowloaded fs flobal mesh's latest V3 installer. It keeps saying " Not all the files are found and drive C needs to have more than 30GB space " My drive C has already more than 30GB and i have all the necessary files. Does any body has the same problem ? Any solution ?

Just released. Check out the .org site !!!

whats your rendering settings. fps looks quite low to me hdr on ?

Luckily it happened before V1 Imagine you are taking off with this burning jet engine