mmaier

Hi Bryan, the last Fly from EDDM to EDDF and taxi to the gate was without any probelm. AFTER LANDING PROCEDURE during TAXI IN a cooldown was present LIGHTS AND DOORS and now at the gate SHUTDOWN PRECEDURE Captain done SHUTDOWN PRECEDURE FO ok SECURE PRECEDURE FO ok now ready for the PREFLIGHT PROCEDURE thanks for your patience One things i missing is setting of AUTOBREAK to RTO by the FO during the BEFORE TAXI PROCEDURE regards Manfred Maier

Hi Bryan, as i pointed out, "all the work of CAPTAIN is done" YES, i should down the engines, first #2 regards Manfred Maier

Hi, i get the same issue (Button Control, FSX NGX Reboot) during the TAXI the cool down THREE MINUTES was present Stand at the Gate LIGHTS AND DOORS (main button) taxi light is off APU on the bus etc. All work of CAPTAIN is done No Action of FO SHUTDOWN CHECKLIST (main button) FO calls out "standby" +++ what is the Trigger for the SHUTDOWN PROCEDURE ? +++ regards Manfred Maier

Hi Bryan and Romain, excuse me for the Statement Heading-Set (degrees) about ProAct/x. I have make a new test,, the only Heading-Set (degrees) is on ground when the Airplan is set to (FSX) Position. Manfred Maier

Thanks Bryan Manfred Maier

Hi, i have a look to "Logs" Result: File FS2CrewCVR.log not found File FS2CrewSpeechEngine.log not found where should the Files be ? Manfred Maier

Hi Bryan, Many thanks for your replay. I`m not intrestet in distance but in Heading-Degrees. I think, this is also not possible with PMDG SDK. Best regards Manfred Maier

Hi, is it posible for the FO to set the Heading-Value about 2-3nm before a new LEG to the FMC-Value. I have see this in PRO-ATC/x. Regard Manfred Maier

I have the same issue and a few more (loade-time, no sync to arcraft) with LINDA 2.3.6 now back to LINDA 1.13 and all is working again without any probelm. Maybe a hartware-clitch, comming from the Device (Botton,Switch ect.) over the USB-Interface. A clitch can also be generated by short Software Actions.

Also both CMD (CMD A and CMD B) should be selected ! mmaier

Thanks for your reply. I have found my mistake. In most cases, the error is sitting before the Computer. The Error-MSG "ERR at N LN:10" simple means: The Error is Close to Char "N" into the CodeLine 10

I have been created my own Airport and change the NAVDATA Files in the manner, descriped in "tutorial sid e star PMDG ENG.pdf" On the RTE-Page1 with LSK 1L take over the ICAO code of my own Airport. At this action i get an Error-MSG: "ERR at N LN:10" I could not find any clue into the Manuals "PMDG-NGX-FCOMv1 and v2.pdf Can anyone help me ?