BrunoAlexander

Hello, my previous installation (v3) gives me a lot of GTN options during the installation process. During the installation of v.4.1A i can not choose between one GTN or two or without GTN. So, at the end I have no GTN in the virtual cockpit. I have P3d v4.2 and GTN complete from flight1. Any ideas? Thank you! Alexander Edit: I have overlooked the new Management Tool. Now you have to choose the GTN options after the installation.

Now it is working. I used Berts GTN mod with the new version, but it is not compatible. Without the mod I can start the engines. My fault. Alexander

Same here (p3d v4.2). What are they doing? Do they ever test anything? Alexander

Thank you Bert! V4.3 works wunderbar. Alexander

xxd09: Have you used the carenado gtn installer? And: Shift + 3 brings up a menu where you can enable/disable the GTN too. Alexander

At the left side of the cockpit, there is an audio panel. Here you can switch voice/ident and make volume adjustments. But I dont know if its working. Alexander

Press Shift + 3 This opens a small menu where you can open doors, etc. Alexander

If you move your mouse pointer over the altimeter knob (Tooltip), it shows you both. Alexander

- AP source selector (GPS/Nav1/Nav2) does not work in VC, only pop up works. - GTN750 in VC: After some time the pup up screen freezes. VC screen not. - After engine shut down, sometimes propellors do not stop spinning. Alexander

Go to your SimOjects/Airplanes/CarenadoSF34 folder and run F1GTN750S340.exe . Have fun! Alexander

Hello, The TrueGlass rain effect is not working. Do I have to do special adjustments or need a special gpu? And yes, its raining outside . I have p3d 4.2 installed. Thanks, Alexander Edit: Its working! I didn´t know, that I had to run the TrueRain installation file in the Milviz folder.

Thank you Roberto. I guess even if i do not have a gps installed, i can not switch?!

How can i switch the VOR / Glidscope Indicator source from NAV1 to NAV2? There is nothing about it in the manual. Alexander

Thanks Molly! I thought it was an current update for p3d. Alexander

Yes, that was my mistake. Thank you Bert!