I reading the Low drag ILS profile and it says at 1000 AGL press the upper left hand of the Chronometer for height check, there is no upper left hand on my chrono and the only click spots seem to just adjust the time? Any suggestions

I reading the Low drag ILS profile and it says at 1000 AGL press the upper left hand of the Chronometer for height check, there is no upper left hand on my chrono and the only click spots seem to just adjust the time? Any suggestions

Can anyone else confirm this?

A picture is worth a thousands words :( It is a digital display, so there are no hands, except the timer hand, and the click spots which I have put a yellow dot on are to start the timer and adjust the time, that it there is no spot to click for a height check, and I guess if you don't call for that height check the FO never calls LAND or GA. Im using the FSX version 1.42A which is the most updated version, and have tried it in both the 2D and VC.

I think I read the instructions wrong it says to press the upper left hand BUTTON of the chrono, I thought it meant the left hand of the clock which there was none, I'll try it again but Im sure that upper left button just starts the chrono at least it does on the ground, I'll try it again after completing the the landing checklist and see if it works.

You need to press the chrono button (CHR) which is in the top left corner of the clock, which is below the VSI. The clickspot is active once the first stage of flaps is selected. Works fine with FS9 version - I doubt it's different with FSX.Confirm you're doing this?Kimmo Kyle

Im 99% sure this is the case, I'll check it out next flight, thanks everyone for the help.

I confirm that it works that way, you've got the 1000 FT AGL call when clicking on this button.Even when I just want to start/stop/reset the chrono for all my non precision approach flights ( :( ).Bryan, I think you should remove this in the future Voice Commander version for the B767 :( :(