When I try to use the repaint manager to load the new paints I downloaded I get an error message that says "Aircraft.cfg file is Read-Only! Would you like to remove the Read-Only status?" I just pressed cancel and haven't done anything since. I looked in the manual but it didn't say anything about that error message so I just want to know if I should go ahead and press Yes and continue? Here is a shot. Sean Campbell

When I try to use the repaint manager to load the new paints I downloaded I get an error message that says "Aircraft.cfg file is Read-Only! Would you like to remove the Read-Only status?" I just pressed cancel and haven't done anything since. I looked in the manual but it didn't say anything about that error message so I just want to know if I should go ahead and press Yes and continue? Here is a shot. Sean Campbell

My friend say yes and contuine it will be ok i was told earlier it worked for me

Great it works now. Thanks Sean Campbell

You are welcome but i must say another member on here helped me, that's what it's all about

Can only install one livery, install a new, the old entry kill. Only the textures are copy to the folder AND every time, i install a livery, my EZDok Cam entry is deleted in the Aircraft.cfg

I'm having the same issue Markus is describing.

I'm getting the same message. I reply yes, the manager starts up but then stops.

are you running the manager in admin mode

Thanks Steve. I've rolled her into the hangar for the night but will check first thing Friday.

Gettin the same problem here too. Only one livery other than the house shows up but when I go to re install a livery, it says the texture folder already exists. However, it is not visible in the installed liveries list.

admin or not, always the same result, go now the old way and write the .cfg from hand.