Not sure why the lettering on the panels are so faint and unreadable. This has been observed only on the NGX. All other addons are just fine. sam bertien

Sounds like you are zoomed out too far (fisheye view?). I have no problem reading everthing. Also make sure that your Global Texture Resolution slider (Options -> Settings -> Display -> Graphics) is all the way to the right.

Sounds like you are zoomed out too far (fisheye view?). I have no problem reading everthing. Also make sure that your Global Texture Resolution slider (Options -> Settings -> Display -> Graphics) is all the way to the right.

Thanks, Jigsaw. Actually, this is in the 2D panel mode and all modes for that matter. sam bertien

2D panels are fine as well, I just checked. Perfectly readable. What is you monitor size? Or maybe it's a graphics driver problem?

This is by far the clearest panel I have ever seen. Make sure your graphics card is set up properly or your FSX settings are correct

2D panels are fine as well, I just checked. Perfectly readable. What is you monitor size? Or maybe it's a graphics driver problem?

ASUS VW246H - 24"Graphics card: GTX 470 Not sure if it is my config. It that was the case, all other addons would be affected. sam bertien

I had the same problem when I got the NGX. I just put the graphics slider full. Maybe thats not it though. But play around with your graphics settings. Good Luck!

I find the panels gauges and text are extremely clear and crisp on the NGX, however if you zoom out too far that will change as with any aircraft but the NGX is the best I've seen.

It might be something as simple as your display settings. Go to your control panel, select display, and check resolution settings. I had the same problem early in the NGX setup.