I just downloaded and installed the 737NGX. All is working fairly well except in the external view, I can see through the fuselage. (i.e.- I can see the seats, it's completely transparent) I thought maybe it was just a delay in the textures loading so I gave it a couple of minutes, but no luck.Thoughts?Thanks,Dave

Did you try the HIGHMEMFIX line as mentioned in the intro manual ? (page 12)That usually solves this problem.Fred.

I have not. Thank you

Ok, I have tried the above, but still no luck. The exterior view remains clear. (ie.- The skeleton problem)My system is a low end system, but in my short tenure with the NGX seems to be handling well other than this.Are there any less detailed textures out there I can try? I am mainly looking for US carriers.BTW - I just downloaded this yesterday, so i should not have to install SP1, correct?Thanks,Dave

Ok, I have tried the above, but still no luck. The exterior view remains clear. (ie.- The skeleton problem)My system is a low end system, but in my short tenure with the NGX seems to be handling well other than this.Are there any less detailed textures out there I can try? I am mainly looking for US carriers.BTW - I just downloaded this yesterday, so i should not have to install SP1, correct?Thanks,Dave

SP1 is included in the Installer from PMDG.BTW, what are you specs such as processor, GPU, RAM and OS? / Leffe

well, I also have a low end system (2 Gigs of RAM only), and my external textures takes some seconds to load at the begin of the flight... only once they completely disapperead for all the flight.I think is for you pc specs

SP1 is included in the Installer from PMDG.BTW, what are you specs such as processor, GPU, RAM and OS?/ Leffe

Win XP SP2 (32 bit)Dual Core Processor4 GB RAMNVIDIA GeoForce GTS 250

Well you should be able to run the NGX, but with lower settings.Use the included "Performance Manager" in your "Start>Program>PMDG 737NGX...."Also turn down your traffic, clouds and use only low settings for water in FSX.It´s important that you include the HighMemfix in your cfgin the graphic section. (but you said you did)[GRAPHICS]HIGHMEMFIX=1/ Leffe

If you have EZCA, you might need to run the airplane through the EZCA configurator.