Hi I downloads the pmdg 737 ngx and I think it is an amazing product with great detail. I am able to do a full autoland but after landing when I have turned the autothrottle and the flight director off, I turn off the runway and I use my rudder pedals to turn and brake but after landing they don't work as well as they do when I turn before takeoff and the brakes don't work at all, even though it says down the bottom 'brake'. Plz tell mine if they're is something I can do because I can't taxi

Hi,

 

Are you using autobrake? If so can you confirm you have turned it off, even if you switched to manual breaking it could still be on.

 

Kind regards

 

Greg

Yes I made sure that the autobrake switch was off and that it doesn't say brakes down the bottom, it only says that when i press the rudder pedals

Have you disconnected the AP after the autoland?  If not, it will fight you when you attempt to exit the runway.  It will remain locked on the localizer even though you will be able to overpower it. 

Check your calibration settings using the Control Manager if you use a CH product and also review and recalibrate your FSX and FSUIPC (if applicable) control settings.

I have done all that but still no luck, any other suggestions

Calibrate your brakes through FSUIPC and you can adjust the rate/pressure.  Make sure you delete the brakes in FSX if you use FSUIPC.

 

Rob