I've tried everything....including the manual (shift2).  I can't seem to get the autopilot working.  Can't set altitude, or anything else.  What's the secret?

OK....no responses on this so far.  I read (by Googling) that you have to click on the Flight Director button. The Z key does not work with the PA 46.  However, I cannot locate the FD button.  If anyone knows where it is on the VC, please let me know.

 

Stan

This is an automatic message.

 

This topic has been moved from "MS FSX Forum" to "PA46 Malibu Mirage 350P". This move has been done for a number of possible reasons.

• The most likely reason is that the post was off topic.
• The topic could also have contained images or a video that were not appropriate to the original forum it was posted in.
• The images might not have been "illustrative" or "explanatory" in nature.
• The topic could have been moved because we deemed it to be more appropriately placed elsewhere.

Please ensure that your posts are "on topic" and contain illustrative images or videos as appropriate. Do not post videos or images just for entertainment purposes anywhere but in the screen shot or video forums. See our image posting rules here.

 

Members who continue to post off topic posts can be denied entry to specific forums in order to reduce and remove the practice. Your cooperation is appreciated.

If you're talking about the 350P it's between the AI and the altimeter.  Three position switch...middle is FD...up is AP.  I made a LINDA module for it if you have some hardware switches.

Hi Stan,

 

The FD button on the PA 46 is to the left of the standby alt.  Works just as Gregg stated.

 

Jim

Thanks.  I'll look again.

 

Stan

I am confused at how to set heading or nav mode. I have the RXP 530 and 430 set to GPS but the announciator panel only says YD enabled. Even changing the alt or vs gives me nothing. The airplane just drifts on its own.

I was mixed up with another plane, finally figured out how to get the altitude and vs enabled.

Is there any way to get the GoFlight MCP Pro CRS knob to operate on the PA46 GArmin 1000 PFD? I see the HDG works but CRS doesn't. Can that be done with our friend LINDA?

I think you must be asking about the PA46T.  It has G500s (I think).  The support forum is here...

 

http://www.avsim.com/forum/444-pa46t-malibu-jetprop-dl-hd-series-fsx/

 

Does Goflight work with LINDA?

 

Gregg