Hi guys,

 

Just bought the 777-300ER and got the SP1 and it is great but I'm getting completely erroneous ETA on my FMS progress page. i am currently on a BA virtual flight from EGLL to OKBK and the time is 1735 UTC - which is set on the clock. However, my progress page is showing i will reach my next waypoint at 1352 UTC. Now I have used the route uplink from a PFPX flight plan - has that got anything to do with it? if so, that is a bug because the correct time is shown on the PFPX plan.

or is there something I'm doing wrong?

 

also, i seem to be getting an 'ILS ANTENNA' caution for some reason

nice work guys like the weather radar and the flight dynamics changes. any help greatly received

I have delete all old panelstates and the time is correct..

also, i seem to be getting an 'ILS ANTENNA' caution for some reason

 

Delete your custom panel states (not the PMDG states) and start from scratch. I had all kinds of weird alerts on the first run as it was using a custom pre-SP1 panel state.

 

Best regards,

Robin.

 

 

also, i seem to be getting an 'ILS ANTENNA' caution for some reason

 

That usually comes from a panel state issue.

 

In this case, my bet is that it's because you didn't follow the instructions to delete your old, pre-SP1 panel states prior to installing the SP.

I have found one solution, 

 

on your clock set the upper right knob to MAN then to UTC.

 

on my aircraft they have changed FMC to UTC time.

 

Marc.

I have delete all old panelstates and the time is correct..

 

Having similar woes. How did you delete the old panel states? Thought I should ask before I start mucking around.

Many thanks.

marc320 you are all right .......very good idea .... it works...very easy ( no needs to cancel anything) :mellow:

marc320 you are all right .......very good idea .... it works...very easy ( no needs to cancel anything) :mellow:

Ok, I admit installing SP1 without deleting my panelstates, following not reading the manual of course. I have issues with the clock.

 

What would be the easiest way to repair the damage? Could I simply make a new panelstate and delete the pre SP1 states, or is it a catch 22 situation?

 

Cheers,