Hi. I don't know where to ask it, so I do it here .

 

I have a strange issue with the 777 and EZCA. When I turn on ground or in the air my camera is also moving (what is ok), but is not moving back to the position I saved. I'm always sitting a bit too right or too left after the turns. I always have to correct this again. This is really annoying.

 

What i have done:

 

After installation of the 777 run the ezca.config

Removed the DHM in the fsx.cfg (set to 0)

 

I can disable the "effects" in EZCA but it doesn't solve the problem.

 

I hope you can help me with this annoying problem.

 

PS: All other planes (737 PMDG, A2A.... ) work fine. 

 

Greetings.

I got the same problem,hope that someone will answer.

I'm not alone, that's "great" for us. What have you done so far?

Philipp,

 

Maybe do a short video of the problem then we could try duplicating/testing ezca camera selection at the same airport e.g.

Ok, here is the video. Please ignore the finger and the shaky cam. I had to do this with my handy. But you will get the problem. The airport is FSIA. 

 

And every time I load a new flight after restarting FSX (same airport), the position in the 777 is different.

 

(Excuse me for the quality, just watch the problem. )

 

 

Philipp,

 

Ok, I will go test.

BTY, you ran over the baggage truck!

What baggage truck?  :ph34r:  B)

on page 134 of the 777 intro manual they talk about this, basically it's an fsx quirk

 

cheers

-andy crosby

Philipp,

 

 

I never purchased the PMDG T7 (was not completed .. many problems) so I tested here in the iFly737.

You damaged the baggage cart .. I think they took the handler to hospital!

 

ezca turns tests
https://www.dropbox.com/s/578f6vzfjcx29kb/Baggage-truck.jpg

 

Thank you for the video and your support.

 

The 737NGX is working fine (also for me). The 777 is the only aircraft with this problem. 

 

During the turn the camera "stuck" in a random position and I don't know what to do and what's causing it. :/

Philipp,

 

"The 737NGX is working fine (also for me). The 777 is the only aircraft with this problem."

 

"During the turn the camera "stuck" in a random position and I don't know what to do and what's causing it. :/"

 

Well, I do not think it is a problem with FSX  or EZCA then.

Do you think this is a problem with the 777?

Hm, very strange. 

Ok you are right. I disabled EZdok and the problem still exists.

Do you think this is a problem with the 777?

Hm, very strange. 

I do not know.

 

I noticed you have EZCA "blue" button ON for 360 ... I did not test that.

That is the only other difference .. other than the PMDG T7 ...

This does not happen in planes I have either but I've seen complaints about this before. It's either PC system or the plane.

That is a FSX issue. It also happens in other planes than the PMDG 777 but the effect is smaller and you don't recognize it.

If you are near the equator you will recognize it more than e.g. in ESSA (Stockholm, Sweden).
I know, it's strange, but try it yourself