June 18, 201510 yr I tried using ORBX GLOBAL, and VECTOR but had to go back to Mega scenery earth 2 as I was having OOMs and low frame rates. I also have NA north CA and soon had to drob using it... So far in P3d no OOMS and good frame rates using 777 and NGX with mega earth, I only load the area I am flying in. percy lee
June 18, 201510 yr Without reading all of the posts - night and day in P3D - 777 was unusable for me in FSX - P3D no problems - carry on Rich Sennett
June 18, 201510 yr I see a lot of replies related to visuals and FPS in P3D, but what about VAS and OOMs? Anybody using the NGX in P3D with ORBX Global and Vector? My FSX:SE setup is OOM-ing, even with the DX-10 Fixer... I basically have to turn off all the features in Vector in order to get from A to B without crashing the sim on approach.Thanks,Ben Holzer I tried using ORBX GLOBAL, and VECTOR but had to go back to Mega scenery earth 2 as I was having OOMs and low frame rates. I also have NA north CA and soon had to drob using it... So far in P3d no OOMS and good frame rates using 777 and NGX with mega earth, I only load the area I am flying in. percy lee If you push to hard or set up vector the wrong way then yer bad fps and OOM all in the link below. David Murden. MSFS • Fenix A320 • PMDG 737 • MG Honda Jet • 414 / TDS 750Xi • FS-ATC Chatter • FlyingIron Spitfire & ME109G • MG Honda Jet • • Fenix A320 Walkthrough PDF • Flightsim.to • DCS • A10c II • F-16c • F/A-18c • F-14 • (Others in hanger) • Supercarrier • Terrains = • Nevada NTTR • Persian Gulf • Syria • Marianas • • [email protected] All Cores HT ON • 32GB DDR4 3200MHz • RTX 3080 • TM Warthog HOTAS • TM TPR • Corsair Virtuoso XT with Dolby Atmos® • Samsung G7 32" 1440p 240Hz • TrackIR 5 & ProClip •
Create an account or sign in to comment