April 11, 20179 yr Hey guys , I am flying the 737 ngx from pmdg. But the Autopilot wont hold the magenta line during cruise and even gets me to bank angle. I am using P3D ASCA AS16 and Ezdok , I am flying on ivao and have there weather engine disabled..... Anyone got an idea? Even sometimes if i take the plane manually i cant really control it because it does what it wants. Really aprecciate some help. Lucas
April 12, 20179 yr adjust turbulence settings try searching the Hifi forums or google for correct settings.
April 12, 20179 yr Did you try reinstalling the 737 ngx? I remember a similar post not long ago and that's what some dude from PMDG recommended. X-Plane 12 (VR only) - HP Reverb G2 - i5 13600k - ASUS TUF RTX 4090 24GB - ASUS TUF Z790-Plus - Corsair Hydro H115i - Corsair 16GB (2 X 8GB) DDR4 4000 (PC4-32000) C18 1.35V - Samsung 860 EVO SSD 500GB - Windows 11 Pro
April 12, 20179 yr Can you dump the content of the following file C:\Windows\System32\drivers\etc\hosts ? -Jerome "In thrust we trust"
April 12, 20179 yr Open a ticket with PMDG. http://support.precisionmanuals.com/Main/ Or a better place than this forum would be PMDG's There General Forum https://www.avsim.com/forums/forum/351-pmdg-general-forum/ Or there NG forum https://www.avsim.com/forums/forum/432-pmdg-737ngx/ David Murden. MSFS • Fenix A320 • PMDG 737 • MG Honda Jet • 414 / TDS 750Xi • FS-ATC Chatter • FlyingIron Spitfire & ME109G • MG Honda Jet • • Fenix A320 Walkthrough PDF • Flightsim.to • DCS • A10c II • F-16c • F/A-18c • F-14 • (Others in hanger) • Supercarrier • Terrains = • Nevada NTTR • Persian Gulf • Syria • Marianas • • [email protected] All Cores HT ON • 32GB DDR4 3200MHz • RTX 3080 • TM Warthog HOTAS • TM TPR • Corsair Virtuoso XT with Dolby Atmos® • Samsung G7 32" 1440p 240Hz • TrackIR 5 & ProClip •
April 12, 20179 yr Sorry to ask a dumb question, but are you sure you're not in heading select mode? Best regards, Neal McCullough
April 13, 20179 yr 18 hours ago, Lucas443 said: i even did a clean install... the problem even remains if i turn off as16 Then you are not doing the correct procedures is lnav/vnav engaged? take a picture and post the screenshot.
Archived
This topic is now archived and is closed to further replies.